Water binders in beef patties increase yield and extend shelf life.

Identifying nonallergenic, natural water binders to increase beef patty juiciness and extend shelf life would be beneficial to the beef industry. The objective of this study was to determine the effect of integrating water binders into beef hamburger patties on cooking yield, shelf life, and pH. Five water binder treatments were added at 2% of the meat block. Treatments included potato extract, citrus fiber, dried refried beans, potato peel, or no binder (control). Six batches of each treatment were made and two patties from each batch were analyzed for each parameter. Fluid yield and lipid oxidation were measured on cooked, frozen (210 d), and reheated patties. Raw patties were used to evaluate color, fluid loss, and lipid oxidation over 4 d of retail display. Patties containing citrus fiber improved reheat yield (P = 0.03) and overall yield (P < 0.01). Citrus patties had the lowest pH (P < 0.01) at 5.45. On days 0 and 4 of retail display, patties containing a water binder treatment had less lipid oxidation than the control patties (P < 0.01). Additionally, the cooked, frozen, and reheated patties, had less lipid oxidation when containing a water binder treatment than the control patties (P < 0.01). Citrus fiber improved water retention in reheated patties, and all water binders delayed lipid oxidation in raw, cooked, frozen, and reheated patties. Increasing patty juiciness and delaying lipid oxidation will improve consumers' eating experience of reheated, precooked patties in settings such as school or hospital cafeterias.

Evaluation of growth, meat quality, and sensory characteristics of wool, hair, and composite lambs.

The objectives of this study were to evaluate the growth rates, carcass quality, shelf-life, tenderness, sensory characteristics, volatile compounds, and fatty acid composition of wool, hair, and composite (wool × hair) lambs. Twenty-one wether lambs [wool (Suffolk × Polypay/Targhee; n = 7), hair (Dorper × Dorper; n = 7), and composite (Dorper × Polypay/Targhee; n = 7)] were fed from weaning to finishing at the University of Idaho Sheep Center and subsequently harvested under United States Department of Agriculture inspection at the University of Idaho Meat Lab. At 48 h postmortem, carcass measurements were taken to determine the percent boneless closely trimmed retail cuts, yield grade, and quality grade. Loins were fabricated from each carcass and wet-aged at 0°C until 10-d postmortem. Following aging, 2.54-cm bone-in loin chops were cut and randomly assigned to 4 d of retail display, Warner-Bratzler Shear Force (WBSF), or sensory analyses. Thiobarbituric acid reactive substances were analyzed on days 0 and 4 of retail display while subjective and objective color measurements were observed once daily. Samples (24 g) were also collected for volatile compound and fatty acid analysis. A mixed model analysis of variance was used to assess breed differences. Discernable effects were considered at P < 0.05. Wool lambs had heavier hot carcass weights (P < 0.001), larger rib-eye area (P = 0.015), and higher dressing percent (P < 0.001) than the other breeds. There was an interaction observed between breed and days of retail display for browning (P = 0.006). On day 1 chops from the composite breed had more browning than chops from the wool breed. No differences were observed between groups for lean muscle L* values (P = 0.432), a* values (P = 0.757), and b* values (P = 0.615). Differences were not observed in lipid oxidation (P = 0.159), WBSF (P = 0.540), or consumer acceptability (P = 0.295). There were differences found for 7 of the 45 fatty acids detected and in 3 of the 67 volatile compounds detected. In conclusion, wool lambs were heavier and had a greater carcass yield than the hair lamb carcasses. Regardless of breed, consumers did not detect sensory traits that would impact their eating experience.

The U.S. lamb industry has been steadily losing production operations since the 1990s due to a decline in lamb consumption, caused by consumer flavor preferences, an increase in synthetic fabrics, and importation from Australia and New Zealand. This has limited the overall need for U.S. producers. The focus of this research was to evaluate the differences among wool, hair, and composite groups of lamb for growth traits, carcass characteristics, shelf-life stability, consumer flavor, volatile compounds, and fatty acid profiling. The study found the wool group maintained a higher overall weight, as well as a taller shoulder height, and heart girth circumference over the hair group. The wool group also had a superior final carcass size; however, the quality grade did not differ between the composite and wool groups. There was no difference between groups for consumer sensory levels or cook loss. Minimal variation was shown throughout the retail shelf-life; however, general discoloration increased as expected during retail display. Tenderness levels between groups were also similar. Volatile compounds showed differences for three compounds with variation between groups. Fatty acid analysis also determined seven compounds of interest; however, common fatty acids known to be flavor factors were not different between groups.

Impact of beef carcass size on chilling rate, pH decline, display color, and tenderness of top round subprimals.

Beef carcass weights in the United States have continued to increase over the past 30 yr. As reported by the United States Department of Agriculture, grid-based carcass weight discounts begin when carcasses exceed 408 kg. Despite weight discounts, beef carcass weights continue to increase. At the same time, an increased prevalence of discoloration and color variability in top round subprimals has been observed throughout the industry which may be influenced by the increases in carcass weights. The objectives of this study were to assess the effects of beef carcass size and its relationship to chill time, color, pH, and tenderness of the beef top round. In the current study, eight industry average weight beef carcasses (AW, 341-397 kg) and eight oversized beef carcasses (OW, exceeding 432 kg) were evaluated. Temperatures and pH measurements were observed on both sides of all carcasses for the initial 48 h postharvest at a consistent superficial and deep anatomical location of the respective top rounds. Carcasses were fabricated into subprimals at 48 h and top rounds were aged at 2 °C for an additional 12 d. The superficial location of both AW and OW carcasses cooled at a faster rate (P < 0.01) than the deep locations. The deep location of OW carcasses had a lower pH and a more rapid (P < 0.01) initial pH decline. Quantitative color of steaks from OW carcasses had greater mean L* (lightness; P = 0.01) and initial b* (yellowness; P < 0.01) values. The delayed temperature decline and the accelerated pH decline of the deep location of the top round of OW carcasses occur at different rates than AW carcasses. Delayed rate of cooling leads to irreversible impacts on steak appearance of top round steaks fabricated from OW beef carcasses when compared with AW carcasses.

Relationship between heifer carcass maturity and beef quality characteristics.

Our objective was to determine the relationship between heifer carcass maturity and beef palatability of the longissimus lumborum (LM) and biceps femoris (BF). Left sides of A (n = 30), B (n = 30), and C (n = 30) maturity heifer carcasses under 30 mo of age by dentition were used. Carcasses were selected to ensure similar marbling scores across maturity groups (Small to Modest). Beef strip loins (LM) and outside rounds (BF) were obtained from these carcasses. Steaks were used to measure color stability, lipid oxidation (thiobarbituric acid reactive substances; TBARS), Warner-Bratzler shear force (WBSF), soluble and insoluble collagen, and consumer sensory perceptions. Heifer carcass maturity did not affect pH, fluid loss, WBSF, or collagen content of LM or BF steaks (P > 0.29). In LM and BF steaks, a maturity × day of retail display interaction occurred for TBARS, in which B maturity steaks had lower levels of lipid oxidation compared with A and C maturity steaks from the fourth day to the end of the retail display (P < 0.01). Nevertheless, LM steaks from B maturity carcasses tended to have lower overall acceptability (P = 0.08) and juiciness (P = 0.09) than steaks from C maturity carcasses, but steaks from B and C maturity carcasses did not differ from LM steaks obtained from A maturity carcasses. No differences in tenderness or flavor were observed due to maturity (P > 0.24). Similarly, maturity had no effect on sensory characteristics of BF steaks (P > 0.30). In conclusion, our results indicate that advanced physiological maturity does not decrease palatability of strip loin or outside round steaks from carcasses of heifers under 30 mo of age.

Assessing outcomes of genetic selection panels to predict marbling in crossbred beef cattle.

The objective of this study was to evaluate the effectiveness of genetic panel marbling indexes [Igenity (IT) and PredicGEN (PG)] to predict marbling and tenderness of crossbred cattle. Steers (n = 23) were harvested at the University of Idaho Meat Science Laboratory, and blood samples were submitted to Neogen and Zoetis for genetic panel analysis. Forty-eight hours postharvest, one boneless strip loin was collected from each carcass, and six 2.54-cm thick steaks were cut from each strip loin. Steaks were aged for 14 and 21 d and assigned to consumer sensory evaluation or Warner-Bratzler Shear Force (WBSF) analysis. Results were analyzed using the Mixed Model procedure of the Statistical Analysis System (SAS Institute, Inc., Cary, NC). Carcasses were grouped by marbling index score into Low IT (IT indexes 3-6; n = 16; marbling score (MS) = 410), High IT (IT indexes 7-10; n = 7; MS = 496), Low PG (PG index <50; n = 9; MS = 398), or High PG (PG index ≥50; n = 14; MS = 458). Mean MS was observed to be greater in High IT steaks than Low IT (P < 0.01) and greater in High PG steaks than Low PG (P = 0.01). There was a trend observed in WBSF between IT marbling groups (P = 0.06); however, no difference in WBSF was observed between PG marbling groups (P = 0.83). Consumers did not report differences between IT marbling groups in terms of acceptability (P = 0.99) or tenderness (P = 0.24). Additionally, consumers could not detect differences between PG marbling groups in terms of acceptability (P = 0.75) or tenderness (P = 0.40). Consumers consistently preferred Choice steaks over Select steaks in terms of acceptability (P = 0.02) and tenderness (P = 0.02). In conclusion, though consumers were not able to tell the difference between steaks from each of the genetic panels, using genetic panels to predict marbling, in conjunction with proper nutrition and handling practices, could be a beneficial tool to producers making decisions about retaining ownership at the feedlot.